Zepoxy Electro pot Clear
Zepoxy Electro Pot Clear Low viscosity, high gloss, electronic component potting adhesive.
Product Description
These are typical results under laboratory conditions, actual coverage and timings may vary as per actual working environment.
TECHNICAL TABLE AND TYPICAL PROPERTIES
| Property | Test Method | Result |
|---|---|---|
| Appearance Part A | - | Medium viscosity, Clear liquid |
| Appearance Part B | - | Low viscosity, Clear liquid |
| Viscosity @ 25°C Part A | ASTM D 2196-05 | 15,000 – 20,000 |
| Viscosity @ 25°C Part B | ASTM D 2196-05 | 300 – 600 |
| Mix ratio (Part A: Part B) | ASTM D 2074 | 100: 50 |
| Pot life (15g mix) @ 25°C | - | 3.5 hour |
| Gel time (24.6g mix) @ 30°C | 3h 40m | |
| Hardening time | - | 24 hour |
| Flexural Strength | ASTM D 790 | 86.7 Mpa |
| Compressive Strength - Ultimate | ASTM D 695 | 74 Mpa |
These are typical results under laboratory conditions, actual coverage and timings may vary as per actual working environment.
USAGE GUIDELINE
Premix Part A at high speed with a mechanical mixer for 5 minutes, then add Part B and further mix at medium speed for 5 minutes. After pouring the mix in the electronic components, the generated foam will finish by itself after some time. Once the epoxy is tack-free, for superior final performance post-cure it at elevated temperature for 2-4 hours.
PAKAGING
Zepoxy Electro Pot is available as follows:
1.5 KG Set Part A: 1 KG
Part B: 0.5 KG
15 KG Set Part A: 10 KG
Part B: 5 KG
30 KG Set Part A: 20 KG
Part B: 10 KG
HEALTH AND SAFETY
Dispose containers of the materials as per local laws, rules, and regulations. Use gloves, safety masks and other safety apparel as per health and safety laws. For further assistance, please refer to the MSDS of the product for further health and safety information.
